Peppercorn steak, celeriac mash & green beans
French-inspired · French steak au poivre inspiration with alcohol-free cream sauce and celeriac-potato mash.
A French bistro-inspired peppercorn cream sauce with sirloin, earthy celeriac-potato mash and green beans; made without alcohol.

How to make peppercorn steak, celeriac mash & green beans
Before you start
Ingredients are scaled for 4. Measure these amounts first. Use a wider pan or batches for larger portions.
- Measure before heating
Measure the listed oil first. Where the method uses half or the remaining oil, divide that measured amount rather than adding an extra full measure. Have a small jug of water ready for any splash the method calls for.
- 1
Boil the roots
Cut celeriac and potato into 2 cm cubes. Cover with additional water in a saucepan, bring to a boil and simmer for 18–22 minutes until soft; drain thoroughly.
What to look forBoth roots crush easily with a fork.
Weigh the celeriac after removing the tough skin.
- 2
Mash and steam
Mash the drained roots with the milk and 1 g of the listed salt for 4 servings. Keep covered over very low heat. Steam beans for 6–8 minutes until tender.
What to look forMash is fluffy and the beans are tender but hold their shape.
Do not blend the potatoes, which can turn gluey.
- 3
Sear the steaks
Pat steaks dry. Season with 1 g salt and half the crushed pepper for 4 servings. Heat oil in a skillet over medium-high heat and sear steaks in batches about 3–5 minutes each side. Check the thickest part away from bone with a food thermometer: at least 63°C / 145°F before removing from heat. Rest on a clean plate for at least 3 minutes.
What to look forThe crust is browned without burnt pepper.
Lower the heat if the pepper begins to blacken.
- 4
Reduce the pepper sauce
Finely dice shallots. Reduce skillet heat to medium-low; soften shallots in the remaining pan oil for 3–4 minutes. Add the listed water and scrape up browned bits. Stir in cream, remaining pepper and remaining 1 g salt for 4 servings; simmer gently 3–5 minutes.
What to look forSauce lightly coats a spoon and shallots are tender.
Discard burnt pan residue rather than incorporating it into the sauce.
- 5
Finish the plates
Divide mash and beans among 4 plates. Add the rested steak and spoon the peppercorn sauce over the meat.
What to look forAll sides are hot and sauce coats rather than floods the plate.
Warm the mash gently with a splash of water if needed.
Tips & troubleshooting
Food is pale and releasing water
Give pieces more space and let surface moisture evaporate. Brown in batches when needed, then continue with the method; raising the heat sharply can scorch the outside before the center is ready.
The sauce is too thick or too thin
If it catches before the ingredients finish cooking, reduce the heat and stir in water a spoonful at a time. If too thin, simmer gently uncovered, stirring and checking often. Remove cooked delicate ingredients first if further simmering would overcook them.
Need a hand at the stove?
Find a practical next step for this dinner.
Beef is chewy or tough
See the stepsWhy your stir fry is watery, and how to fix it
Read the guideHow to stop food sticking to a stainless steel pan
Read the guideTemperature guidance: USDA safe minimum internal temperatures.
Recipe references
Page information updated .
Tomato-mushroom chicken chasseur & potatoes
Turkey meatloaf, mash & green beans
Chestnut & celeriac soup with rye croutons